Browse Categories
Find by Competition/Race Car For Competition Trucks Engine Swaps Coilovers
CXRacing LS1 Engine Mount + T56 Transmission Mount + Subframe + Rear End Differential Bracket For 1989-1997 1st Gen NA Mazda Miata MX-5 With LS1 Swap

-Heavy Duty Construction Using 7 Gauge (0.18") Thickness Stainless Steel Panels and Tubes.
-Retains Factory Steering Geometry, Bolt On Factory Steering Rack and Pinion.
-Retains Factory Suspension System.
-Comes with Engine Mounts for LS1 Engine
-Comes with T56 Transmission Mount
-Comes with Rear End Differential Bracket for Stock Diff
-Comes with Swaybar Spacer, 4.5" Height

Note: Some Brackets Need to be Welded on the Chassis for Stronger Support, See Pictures

APPLICATION(S)
Chassis: 1989-1997 1st Gen NA Mazda Miata MX-5
Motor: LS1
Transmission: T56

What's in the box:
This is for the Parts Listed Below, All Other Parts Shown are NOT INCLUDED.

Products:
Subframe, with Swaybar Spacer x1
Set of Engine Mount x1
Set of Transmission Mount x1
Set of Differential Bracket x1


Write a review

Please login or register to review

LS1 Engine T56 Trans Mounts Subframe Differential Bracket For 89-97 NA Mazda Miata MX-5 LSx

  • Brand: CXRacing
  • Product Code: ESK-TM-LS-SUBFRAME-MIATA9098
  • Availability: In Stock

  • $2,000.00


0 reviews / Write a review

  • Emission Notes:

  • All Parts and services offered by CXRACING are for competition vehicles only. Use on State and Federal Highways may be a violation of the EPA Clean Air Act. The Clean Air Act can be found at http://www.epa.gov/air/caa/. This document contains in detail what are considered to be violations of the CAA and corresponding penalties for failure to obey and should be read in full before purchasing or installing this competition use only product. Ensuring that all emissions, noise/sound, and speed/use related laws are followed is the responsibility of the Buyer(s). Installation and use of this product indicates that this disclaimer has been read, acknowledged, and understood fully by both the Buyer(s) and Installer(s). The Buyer(s) assumes all associated risk of the purchase.

  • Federal and several state laws prohibit the removal, modification or rendering inoperative of any part that affects emissions or safety on motor vehicles used on public streets or highways. CXRacing assumes no liability for any violations arising out of any federal, state or provincial emissions or safety requirements on motor vehicles arising out of the customer’s modifications and/or use of CXRacing products. It is the responsibility of the customer to determine if their modified vehicle complies with applicable laws.

  • PROPOSITION 65 WARNING

  • These products may contain chemicals known to the State of California to cause birth defects or other reproductive harm. For more information visit www.P65Warnings.ca.gov.