CXRacing Ball Bearing GT45 76mm Wheel Turbo Charger + Oil Line Kit
With Vband Flanges And Clamps (3.5" Vband Compressor Outlet, 4" Vband Exhaust Outlet)

Stage III Ceramic Ball Bearing on Compressor Side
Anti Surge Turbo Inlet with Vband Oulet
1.15 A/R Turbine Housing For Super High Exhaust Flow Motors
T4 Divided Flange to Manifold
V-Band Downpipe Flange: 3.5" ID (Fits 4" Vband Flange)
Turbo Air Inlet: 5"
V-Band Turbo Compressor Outlet: 3.25" ID (Fits 3.5" Vband Flange)
Works for Many Bigger HP Applications.

This is a High Performance High Output Ball Bearing Turbo. We Have Dyno Tested This Turbo with Our LS1 Turbo Kit on a 383 Stroker LS Motor (Stroker 5.3L Truck Motor), It Makes Close to 900 HP at 15PSI (with 80mm Wheel Turbo), This One is 76mm Wheel Turbo, So It Makes Around 800 HP.

Item(s) Specification:
- 5" Air Inlet
- 3.25" Vband Compressed Air Outlet - Ceramic Ball Bearing on Compressor Side Compressor
- Standard T4 Turbine Housing Flange
- 3.5" V-Band Exhaust Outlet
- Oil Cooled
- 0.60 A/R Compressor
- 1.15 A/R Turbine
- Compressor Wheel (Major/Exducer): 76.6/103.6mm
- Turbine Wheel (Major/Inducer): 77.4/88.9 mm
- Works for Many Bigger HP Applications

Highlights:
- High Quality Built Product. Each Turbo is Individually Tested and Computer Balanced.
- BRAND NEW, Not Used, Not Remanufactured.

Item(s) Included:
- GT45 Turbo
- 3.5" Aluminum Vband Flange and Clamp for Compressor Outlet
- 4" Stainless Steel Flange and Clamp for Exhaust Outlet
- Oil Line Kit with AN4 Feed Flange and 5/8" Drain Flange and AN4 Oil Line (50" Long)

 

Note: Below Dyno Graph Shows GT45-80mm Wheel Turbo Results, the 76mm Turbo on the Graph is a None Ball Bearing Turbo (Not the Same as the one being sold), So the Turbo being sold should make a little bit less than the 80mm turbo, around 800HP


Write a review

Please login or register to review

GT45 GT45R Ball Bearing Turbo Charger 76mm T4 1.15 A/R + Oil Line + V-Band Clamp Flange Kit

  • Brand: CXRacing
  • Product Code: TRB-GT45-76-R_FLNG_OIL
  • Availability: In Stock
  • $544.55


  • Emission Notes:
  • All Parts and services offered by CXRACING are for competition vehicles only. Use on State and Federal Highways may be a violation of the EPA Clean Air Act. The Clean Air Act can be found at http://www.epa.gov/air/caa/. This document contains in detail what are considered to be violations of the CAA and corresponding penalties for failure to obey and should be read in full before purchasing or installing this competition use only product. Ensuring that all emissions, noise/sound, and speed/use related laws are followed is the responsibility of the Buyer(s). Installation and use of this product indicates that this disclaimer has been read, acknowledged, and understood fully by both the Buyer(s) and Installer(s). The Buyer(s) assumes all associated risk of the purchase.

  • Federal and several state laws prohibit the removal, modification or rendering inoperative of any part that affects emissions or safety on motor vehicles used on public streets or highways. CXRacing assumes no liability for any violations arising out of any federal, state or provincial emissions or safety requirements on motor vehicles arising out of the customer’s modifications and/or use of CXRacing products. It is the responsibility of the customer to determine if their modified vehicle complies with applicable laws.

  • PROPOSITION 65 WARNING

  • These products may contain chemicals known to the State of California to cause birth defects or other reproductive harm. For more information visit www.P65Warnings.ca.gov.